[145] Maintenance Station Buttons
4.
Press the Raise Carriage button and then use the maintenance suction
nozzle to remove any excess ink from the printhead that you purged.
5.
Close the maintenance station door.
6.
In the ink bay, reconnect the ink bag coupler of the target ink bag to re-
initiate ink fill.
7.
Place a lint-free cloth below the bleed tube of the target ink filter to catch
any ink.
8.
Turn the valve shutoff lever so that it is parallel to the bleed tube to open
the valve.
9.
Keep the cloth close as you watch the open bleed tube. As soon as you see
ink appear in the open end of the bleed tube, flip the shutoff lever back to
the perpendicular closed position (this may take a few minutes, depending
on the amount of air in the filter since the ink pump is only active for a
brief period every 5 seconds). Ignore the residual ink that is already in the
bleed tube.
How to Change Ink Filters - How to Bleed an Ink Filter
Chapter 12 - Printer Maintenance
259
User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
