Procedure
NOTE
When you print on the RMO, if the media width entered is less than 1067
mm (3.5 ft) the standard nozzle check will not fit across the media. In this
case, if the Nozzle Check icon is selected from the Print Job Control
command toolbar, the narrow version (Nozzle Check Narrow 886.5 x 214.7
(2.9 x 0.70 ft)) is automatically added to the print queue.
1.
Place a piece of Océ I/O paper on the printer table (or use the RMO, if
available).
2.
Select the Nozzle Check icon at the right end of the Command Toolbar to
place the nozzle check into the Active Print Job list (you can also add a
Nozzle Check to the active print list when you select it from the Special
Prints module).
3.
Confirm media thickness.
4.
Activate the table vacuum.
5.
Push the printer Start button to begin the print.
6.
Print an image to make sure there is no banding or other print quality
issues.
How to Print a Nozzle Check
232
Chapter 12 - Printer Maintenance
User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
