Oce Arizona 250 GT, User Manual

Page: 82 / 178

82 Chapter 5 How to Operate the Arizona 250 GT
How to Set Up a Print Job
How to Set Up a Print Job
Introduction
This section explains how to select an image to print on the Arizona 250 GT. The
basic steps are outlined here and explained below. More detailed explanations for
some of these steps are available Job Control Module.
■
Prepare A Digital Image Using Onyx ProductionHouse
■
Print The Job From Onyx ProductionHouse To The Arizona 250 GT Printer
■
Perform Printhead Maintenance (If First Print Of The Day)
■
Select Job To Be Printed and Check Print Parameters
■
Measure Media Thickness
■
Select Print Icon, select Print Mode, and Confirm Media Thickness
■
Prepare Media for Printing
Place And Register Media On The Printer Vacuum Table
Select Active Print Zones
Mask Active Vacuum Zones Not Covered With Media
Turn On Table Vacuum
Adjust Bleed Valve, If Required
Clean Media, If Required
■
Check the table to make sure that there are no obstacles that can interfere with the
travel of the gantry or carriage
Start the Print
Prepare a Digital Image with ProductionHouse
Operator must be trained to use ProductionHouse, (documentation and training
provided by Onyx).
Print The Job From Onyx ProductionHouse
When the job is sent from ProductionHouse, the job transmission progress is
indicated in the lower right corner of the User Interface display. After the
transmission has completed it will appear in the list of Active print jobs in the Job
Control Module.
Perform Printhead Maintenance (if this is the first print of the day)
Refer to the Maintenance section in this manual for details Printhead Maintenance.
This must be done at the beginning of the work day or when image quality such as
banding appears.