50
Chapter 4 How to Navigate the User Interface
Operator Interface Hardware
Status of Beacon Light States
The status light indicates the following printer status to the operator.
[18]
Emergency Stop Effects
Note:
There are three Emergency Stop buttons, one on the control station podium
and one on each end of the gantry. The AC power On/Off switch can also function as
an emergency stop. There are more details on the Emergency stops in the Interlock
section (
see ‘Interlock Safety System’ on page 29
Activating an Emergency Stop will disable the following:
■
Carriage motion
■
Gantry motion
■
UV curing lamps
■
Ink pumps
■
Thermal fluid (coolant) pump
(14) Carriage Guard The Carriage Guard protects the Operator from exposure to
UV light and it also protects the lamps and the carriage by
stopping all motion if it encounters an obstacle in the path
of the carriage.
(15) Vacuum
Shut-off Valves
On top of the carriage are vacuum shut-off valves can be
shut off to avoid ink drips when the printer is turned off.
They also allow longer purges to select printheads (those
not shut off).
(16) Waste Tray
The waste ink tray is located below the printhead
maintenance station. A manual valve allows the operator to
drain the waste ink to a portable container for disposal .
[17] Hardware Interface Components
(3 – 3)
Component
Function
[18] Status Light
Beacon Status Light
Definition
Possible Conditions
Green Off
Printer interlock system
or the emergency stop
buttons have been
triggered. No motion can
be initiated.
Maintenance station door
has been opened or one
the emergency stop
buttons has been
triggered.
Green On
Printer is functional and
ready to initiate motion.
Summary of Contents for Arizona 250 GT
