Oce Arizona 250 GT, User Manual

Page: 12 / 178

12 Chapter 1 Introduction
Product Compliance
Product Compliance
Introduction
This section details the compliance and agency standards that the Arizona 250 GT
conforms to. It also provides manufacturing and contact information.
Electromagnetic Compliance (EMC)
FCC Statement for Class A Device:
This equipment generates, uses and radiates radio frequency energy and if not
installed and used as designed or intended, may cause interference to radio
communications. This equipment has been tested and found to comply with the
limits for a Class A computing device. This equipment has been designed to provide
reasonable protection against such interference when operated in residential and
commercial environments. Operation of this equipment in a residential area may
cause interference, in which case the user, at his own expense, is required to take
whatever measures are required to correct the interference.
FCC Notice: This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interferece, and
2) This device must accept any interference received, including interference that may
cause undesired operation.
Any change or modification not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
This device contains an intentional radiator (RFID)
Radio Certificate Number: IC:6497A-3010105668
FCC Identifier: U2P-3010105668
Product Safety
Compliance Category.
This equipment is considered to be information technology equipment for use in a
light industrial setting. The equipment falls under the scope of the Machinery
Directive due to the movement associated with the gantry carrying the printer head
carriage assembly. As such, a full risk assessment per EN 1050 and a full mechanical
and machinery assessment per 292-2 + A1 Annex 1 was performed. As the
equipment is primarily information technology equipment (large format printer
receiving data from a computer terminal), and is within the scope of EN 60950
(mains operated ITE equipment under 600V including plotters and photoprinters -
clause 1.1.1, EN 60950: 2000), a full electrical evaluation was performed per EN
60950:2000.