Océ VarioLink 2221, User Manual

Page: 410 / 425

11
Utility mode
11-68 VarioLink 2221/2821/3621
Utility mode
Ch
apt
er
11
11.12 Managing the memory (Memory Management param-
eters)
Data stored on the internal memory can be erased, and all programmed and
specified settings can be set to their defaults.
2
Reminder
Before managing the memory, disconnect network cables other than the
telephone cable from the machine.
If the “Overwrite All Data” parameter on the Memory Management screen
is selected, all programmed and specified settings are reset to their de-
faults. Therefore, the machine may not operate correctly after all data is
overwritten. Overwrite all data when disposing of the machine. Do not
perform this operation in any other circumstances.
Wait at least two minutes after turning on the machine before deleting all
of the data.
Do not touch the machine while deleting all of the data in order to prevent
errors from occurring.
2
Note
The data on the memory cannot be erased while a job is being performed.
To erase all data from the internal memory
1
Display the Admin. 2 screen, and then touch [Memory Management].
– For details on displaying the Admin. 2 screen, refer to “Displaying
the Administrator Management screen” on page 11-21.
– If the optional hard disk drive is installed, [HDD Management] ap-
pears instead of [Memory Management]. For details on the “HDD
Management” parameter, refer to the User’s Guide [Box Opera-
tions].
The Memory Management screen appears.