Service manual
XLP 504 / XLP 506
05/2018 | 04
202
Malfunctions
5064 Rewinder full
Happens with dispenser version printers: Shows up, when the diameter of the rewinded backing
paper roll has become too large.
Clear the rewinding mandrel.
Press key 4 to acknowledge.
5100 Printengine lock
Printengine error (occurs only at devices with Gen. 3 electronics).
Acknowledge by pressing key 4.
Switch device off and on again.
If the message continues to appear:
Contact service technician.
5101 Headadjust error
Error during the running of the "Head Alignment" service function.
Acknowledge by pressing key 4.
Contact service technician.
5110 Foil low
The diameter of the foil roll fell below the set warning diameter (see
System > Print > Foil end warning
).
The message is caused by a foil warning in addition with the following setting:
System > Print > Foil
warn stop
. = „On“
Acknowledge by pressing key 4.
5200 Home position
The applicator did not reach its home position within the given time frame.
May the applicator move unhindered? – remove any obstacles.
5201 Touch down
The applicator did not reach its touch down position within the given time frame.
Check if any product to be labeled was present at all, respectively if the applicator hit the product.
Check, if the sensor cable(s) is/are connected properly
Check, if the sensor(s) is/are soiled.
Check, if the sensor(s) is/are defective.
5203 Touch down sens.
Der (die) Touchdown-Sensor(en) wurde(n) bereits vor dem Appliziervorgang betätigt.
May the applicator move unhindered? – remove any obstacles.
Check, if the sensor cable(s) is/are connected properly
Check, if the sensor(s) is/are soiled.
Check, if the sensor(s) is/are defective.
5222 V x for int. rewinder required
The installed firmware version of the BLDC output stage doesn´t match the installed printer firm-
ware.
Firmware version of the BLDC output stage is
too low
:
Acknowledge the status message; update firmware to the indicated version.
Summary of Contents for XLP 504
Page 1: ...Edition 9 5 2018 Translation of original version SERVICE MANUAL XLP 504 XLP 506 Label printer ...
Page 2: ......
Page 238: ...Service manual XLP 504 XLP 506 05 2018 06 238 Appendix WIRING DIAGRAMS See next pages ...
Page 248: ...Novexx Solutions GmbH Ohmstraße 3 85386 Eching Germany 49 8165 925 0 www novexx com ...