Novexx Solutions XLP 504, Service Manual

Page: 114 / 248

Service manual
XLP 504 / XLP 506
05/2018 | 09 114 Parameter Menu
Mat. end detect.
(Material end detection)
The material end detection can be deactivated for processing labels with gaps longer than 15 mm,
or if using material with a high fluctuation in light transparency (Status message „5002 material end“
is displayed even though material is present)..
• Off : No material end detection
• Transparent : Material end detection by means of a transmission sensor
Foil length
Ribbon length of the applied ribbon roll. The ribbon length is marked on the packaging of the new
ribbon roll. This setting is important for proper functioning of the ribbon-end warning.
Outer foil diamet.
(Outer ribbon roll diameter)
Outer Ø of the applied ribbon roll. This setting is important for proper functioning of the ribbon-end
warning.
Inner foil diamet.
(Inner ribbon roll diameter)
Inner Ø of the applied ribbon roll. This setting is important for proper functioning of the ribbon-end
warning.

Inner Ø of the ribbon roll = Outer Ø of the ribbon core!
Bar code multip.
(Bar code height scaling factor)
Increases the bar code height defined in the label layout (Easy Plug) by multiplication by a factor
of 1 to 10.
Settings Default setting Step width Easy Plug
Off, Transparent Transparent -- --
CAUTION!
Soiling or damaging the print roller.

Endless (= not converted) material should not be processed when the material end
detection is deactivated (otherwise, printing is continued on the print roller after mate-
rial end).
Setting range Default setting Step width Easy Plug
[300...500] m 450 m 10 m #PC1038
Setting range Default setting Step width Easy Plug
[50.0...100.0] mm 79.1 mm 0.1 mm #PC1039
Setting range Default setting Step width Easy Plug
[28.0...40.0] mm 33.0 mm 0.1 mm #PC1040
Setting range Default setting Step width Easy Plug
[1...10] 1 1 #PC1009, #YB