Novell GROUPWISE 7 - INTEROPERABILITY GUIDE, Manual

Page: 65 / 485

Setting Up a Domain and Post Office in a NetWare Cluster 65
n
ov
do
cx (e
n)
11
Ju
ly 20
08
Š
Providing access to users’ GroupWise mailboxes from their Web browsers. See Chapter 5,
“Implementing WebAccess in a NetWare Cluster,” on page 89 .
Š Connecting your clustered GroupWise system to other e-mail systems through GroupWise
gateways. See
Chapter 6, “Implementing GroupWise Gateways in a Novell Cluster,” on
page 107 .
Š Monitoring the status of your clustered GroupWise system from your Web browser. See
Chapter 7, “Monitoring a GroupWise System in a NetWare Cluster,” on page 109 .
Š
Backing up your clustered GroupWise system. See Chapter 8, “Backing Up a GroupWise
System in a NetWare Cluster,” on page 111 .
3.9 Clustering Quick Checklists
Š Section 3.9.1, “GroupWise System Quick Checklist,” on page 65
Š
Section 3.9.2, “Domain Quick Checklist,” on page 66
Š Section 3.9.3, “Post Office Quick Checklist,” on page 67
3.9.1 GroupWise System Quick Checklist
‰ Plan your new clustered GroupWise system.
See Chapter 2, “Planning GroupWise in a NetWare Cluster,” on page 23 .
‰ Cluster-enable the volumes where GroupWise domains and post offices will reside.
See
Section 3.1.2, “Cluster-Enabling Shared Volumes for Use with GroupWise,” on page 43 .
‰ Make sure that short name resolution works throughout your network.
See
Section 3.1.3, “Configuring Short Name Resolution,” on page 44 .
‰ Create the primary domain and initial post office in your new clustered GroupWise system.
See
Section 3.2, “Setting Up a New GroupWise System in a Cluster,” on page 46 .
‰ Set up the agents for the primary domain and the initial post office.
See
Section 3.5, “Installing and Configuring the MTA and the POA in a Cluster,” on page 50 .
‰ Modify the volume resource load script(s):
Š
Remove the
trustmig
command
Š Add the
cvsbind add
command (NetWare 5.1 only; optional)
Š
Add the
search add
command (optional)
Š If you will not run the agents in protected memory, add the
set auto restart
commands and the
set developer option = off
command
Š
Add the agent
load
command(s)
Š
If you will run the agents in protected memory, add the
address space
parameter to
the
load
command(s) and add a corresponding
protection restart
command for
each address space
See “Modifying the Volume Resource Load Script for the Agents” on page 53 .
‰
Modify the volume resource unload script(s):
Š
Add the agent or address space
unload
command(s)