Novell GROUPWISE 7 - INTEROPERABILITY GUIDE, Manual

Page: 50 / 485

50 GroupWise 7 Interoperability Guide
n
ov
do
cx (e
n)
11
Ju
ly 20
08
This option creates the document storage area for the library under the post office
directory and is not recommended for large libraries.
Š The Configure Link option is selected by default. Select TCP/IP Link from Domain to New
Post Office . Refer to the Agent Clustering Worksheet that you filled in during “Planning
Secondary IP Addresses and Cluster-Unique Port Numbers for Agents in the Cluster” on
page 31
for the secondary IP address and cluster-unique port numbers that you need to
specify in order to configure the link.
5 Right-click the new Post Office object, then click Properties .
6
Click GroupWise > Post Office Settings ; in the Access Mode field, select Client/Server Only .
7 Right-click the new POA object, then click Properties .
On the POA Agent Settings and Scheduled Events pages, you might want to specify unique
times for the following POA activities to prevent multiple POAs from performing the same
activities on the same node at the same time during a failover situation:
Š Start User Upkeep
Š
Generate Address Book for Remote
Š Enable QuickFinder Indexing
Š
Mailbox/Library Maintenance Event
For more information about these repetitive POA activities, see “ Performing Nightly User
Upkeep ”, “ Regulating Indexing ”, and “ Scheduling Database Maintenance ” in “ Post Office
Agent ” in the GroupWise 7 Administration Guide .
8
Make sure you are still connected to the domain that owns the new post office.
9 Rebuild the post office database for the new post office, following the steps provided in
“
Rebuilding Domain or Post Office Databases ” in “ Databases ” in the GroupWise 7
Administration Guide . Be sure to browse to the database location ( under System Clustering
Worksheet item 11 ) through the virtual server that was created when you cluster-enabled the
GroupWise volume.
The database rebuild is necessary in order to transfer the POA configuration information and
the post office link information into the post office database, because the POA for the new post
office is not yet running.
10
If you want to create a library with its document storage area outside the post office directory,
(
System Clustering Worksheet item 14 ), follow the steps in “ Setting Up a Basic Library ” or
“ Setting Up a Full-Service Library ” in “ Libraries and Documents ” in the GroupWise 7
Administration Guide , after you have completely finished setting up the clustered post office.
11 Continue with Installing and Configuring the MTA and the POA in a Cluster .
3.5 Installing and Configuring the MTA and the
POA in a Cluster
After you have created a new domain and/or post office, you are ready to install and configure the
GroupWise agents. Complete all the tasks below if you are setting up a new GroupWise system or if
you have created a new GroupWise volume where you want to install the agent software:
Š Section 3.5.1, “Installing the Agent Software in a Cluster,” on page 51
Š
Section 3.5.2, “Editing Clustered Agent Startup Files,” on page 52