Novell GROUPWISE 7 - INTEROPERABILITY GUIDE, Manual

Page: 47 / 485

Setting Up a Domain and Post Office in a NetWare Cluster 47
n
ov
do
cx (e
n)
11
Ju
ly 20
08
2 Map a drive to the GroupWise volume for the domain ( System Clustering Worksheet item 7 )
and, if needed, to the GroupWise volume for the post office ( System Clustering Worksheet item
8 ), where the primary domain and the initial post office for your new GroupWise system will
be created.
The GroupWise volume name will be
cluster _ volume . For assistance with mapping a drive to a
cluster-enabled volume, see “Configuring Short Name Resolution” on page 44 .
3 Manually create the domain directory ( System Clustering Worksheet item 10 ) and the post
office directory ( System Clustering Worksheet item 12 ).
This step is not required, but in a clustered environment, the following step is easier if the
domain directory already exists.
4 Run the GroupWise Installation Advisor to set up your initial GroupWise system, following the
steps provided in “
NetWare and Windows: Setting Up a Basic GroupWise System ” in
“ Installing a Basic GroupWise System ” in the GroupWise 7 Installation Guide . Keep in mind
the following cluster-specific details:
Š When you specify the ConsoleOne directory and the software distribution directory, be
sure to browse to each location through the GroupWise volume accessed in
Step 1 above.
Š
When you specify the domain directory and post office directory, be sure to browse
through the GroupWise volume accessed in
Step 2 to select the directory created in Step 3
above.
Š
For the post office link type, select TCP/IP Link .
Š
When providing the MTA and POA network address information, use the Agent
Clustering Worksheet that you filled out in
Section 2.8, “Deciding How to Install and
Configure the Agents in a Cluster,” on page 31 . The information you provide is used to
configure the MTA and POA objects in the domain and post office even though you have
not yet installed the agent software.
Š
Do not create users in the post office at this time.
Š
In the Summary dialog box, the domain directory and post office directory that you
browsed to should display as UNC paths using the virtual server name with the
GroupWise volume.
5 When you have finished creating the primary domain and the initial post office, continue with
installing the GroupWise Agents, starting with
Step 4 on page 51 in Section 3.5, “Installing and
Configuring the MTA and the POA in a Cluster,” on page 50 .