Novell GROUPWISE 7 - INTEROPERABILITY GUIDE, Manual

Page: 156 / 485

156 GroupWise 7 Interoperability Guide
n
ov
do
cx (e
n)
11
Ju
ly 20
08
2 If this is an NSS volume or a shared pool, make the following changes:
2a In the service
stop
command, change
myservice stop
to the command to stop the
GroupWise agent or agents that you want to run on this GroupWise partition.
If you created a domain on the partition, you need to stop the MTA. If you created a post
office on the partition, you need to stop the POA. If you created both a domain and a post
office, you need to stop both the MTA and the POA. Use the following commands as
needed for your GroupWise partition:
/etc/init.d/grpwise stop domain
/etc/init.d/grpwise stop post_office . domain
2b Adjust the
sleep
command as needed so that the agents can shut down normally on your
system without being inadvertently killed by the kill service command.
2c In the kill service command (used if the agents do not stop normally), change
-k
to
-mk
.
The
-m
parameter obtains the PID numbers of the processes to kill.
2d
In the kill service command, change
/mnt/generic
to the mount point directory used
in the load script.
2e In the
del_secondary_ipaddress
command, change a.b.c.d to the secondary IP
address used in the load script.
2f In the
umount
command, change
/mnt/generic
to the mount point directory used in
the load script.
The result would be similar to the following:
3 If this is a traditional Linux volume, use the following unload script:
#!/bin/bash
. /opt/novell/ncs/lib/ncsfuncs
/etc/init.d/grpwise stop domain
/etc/init.d/grpwise stop post_office.domain
# define the IP address