Nortel 1002rp, Maintenance And Diagnostics

Page: 188 / 218

Replacing voice processing boards Standard 1.11
188 CallPilot
front bezel and server cover” on page 110.
5 Disconnect the CTbus cable (if present)
6 Remove the original MPB96 board from the slot.
7 Unpack the replacement MPB96 board.
8 Hold the MPB96 board by its top edge or upper corners and then
align it with the following:
„
end-plate opening in the chassis (ensure that the tapered foot of
the board’s retaining bracket fits into the slot in the expansion
slot frame)
„
PCI connector
9 Press the new MPB96 board firmly into its slot.
10 Secure the board using the retaining screw.
11 Reattach the CTbus cable.
12 Replace the server cover.
13 Replace the front bezel and lock it.
14 Reconnect the peripheral device and power cables.
15 Reconnect the DS30X cable to the faceplate of the MPB96 board.
Note: Ensure that a single-point ground reference is available for all
the power outlets serving the CallPilot server and its peripherals.
Before the CallPilot server installation, a qualified electrician must
implement the single-point ground reference requirement between
the power outlets of the CallPilot server and the power outlets of the
switch.
16 Power up the server and log on to Windows.
17 Run the Configuration Wizard to detect the new hardware.
For instructions, refer to the Installation and Configuration Task List
(555-7101-210 ) .
Result: The MPB96 board replacement is complete.
18 Restart the server.