Nortel 1002rp, Maintenance And Diagnostics

Page: 164 / 218

RAID operations Standard 1.11
164 CallPilot
3 From the Objects menu select Adapter and press Enter.
4 From the Adapter menu select Factory Default.
5 Select Yes to confirm the selection and press Enter.
6 Press Ctrl+Alt+Delete when prompted to restart system.
7 During bootup, press Ctrl+M to re-enter the RAID setup utility.
8 From the Management menu select Objects
➝
Adapter, then
ensure the values are set as follows:
Flex RAID Power Fail: Enabled
Fast Initialization: On
Disk Spin up Timing: 1 Disk every 6 secs
Cache Flush Timings: Every 4 seconds
Rebuild Rate: 30%
Alarm Control: Enabled
Other Adapter Options:
— Emulation:
Mass Storage
— Auto Rebuild: Disabled
— Initiator ID: 7
— Cluster Mode: Disabled
— Multiple PCI Delayed Transactions: Disabled
— Force Boot: On
— Coercion Algorithm: GigaByte Way
— Cc Restoration: Enabled
Note: The Coercion Algorithm must be set properly. Once changed,
it cannot be changed again. The only way to reset it is to
reconfigure RAID from scratch and load the default configuration,
then reboot.
9 Select Objects
➝
Channel and press Enter. Ensure that the values
are set as follows:
Termination State: Enabled
SCSI Transfer Rate: 160M
10 In the Configure menu, select New Configuration. Press Yes to
proceed.