Nortel 1002rp, Maintenance And Diagnostics

Page: 151 / 218

January 2007 Replacing media drives
1002rp Server Maintenance and Diagnostics 151
Figure 32: Replace media drive - step 2
3 If you are installing a tape drive, configure it as described in “To
configure the tape drive” on page 153.
4 Slide the new drive into the media drive carrier, and secure it with
the screws that were previously removed.
5 Reattach any media drives that you removed to access a specific
media drive slot.
6 Position the media drive carrier in the media drive bay, leaving
enough room to reach behind the carrier, and attach the
connectors.
7 Carefully connect the existing signal and power cables as shown in
“Cabling example” on page 153.
Note: If your tape drive is a narrow device, you require a wide-to-
narrow adapter to connect to the wide SCSI cable.
8 Slide the carrier into the media drive bay.
Note: Ensure that the cables are free and undamaged.
G101748