Instruction Manual
NivuFlow Stick
Page 48
NivuFlow Stick - rev. 00 / 27.01.2020
31.1.2
Name of Measurement Place
Right like in the >Application< / >Measure Place< menu the name of the measurement place
can be modified here. After modification when going back to the main screen the transmitter
goes directly to the main screen without saving and continues to indicate the previous read-
ings. The new measurement place name, however, is shown in the headline and the meas-
urement can be continued using the current parameters. If you wish to modify the pre-set
default parameters use the >Application< / >Measure Place< menu.
See Sect. “30.1.1 Name of measurement place”.
31.1.3
Reference Number
The reference number can be used as an amendment to the measurement place name for a
more accurate definition of the measurement. Users can specify the number manually.
The pre-set default parameters are maintained even if the reference number is changed.
They can be modified only in >Application< / >Measure Place<.
See Sect. “30.1.2 Reference Number”.
31.1.4
Notes
This is the place to enter free text notes (max. 400 characters incl. blanks) which will be
saved additionally.
Fig. 31-2 Entering notes
31.1.5
Quality Trigger min., Calculation, Bank and Measurement Points
Right like measurement place name and reference number, these values can be adjusted
here too. The pre-set parameters, however, are maintained. Default parameters can be
changed only under >Application< / >Measure Place<.
See Sect. “30.1.9 Quality Trigger min.”, “30.1.6 Calculation”, “30.1.7 Bank left,
k(Bank left), Bank right and k(Bank right)” and “30.1.8 Measurement Points”.
31.1.6
Flow, Level, Velocity, Area, Wetted Perimeter and Hydraulic Radius
Indication of measured or computed (average) values on this measurement place. This is a
read-only parameter.