Parameter Setting
NivuFlow Stick - rev. 00 / 27.01.2020
Page 37
Parameter Setting
28 General Programming
As a principle, modified parameters do not become effective before they have been saved.
The instrument verifies whether parameters have been changed when you exit menus by us-
ing “Back”. Finally, you will be prompted to eventually save modified parameters.
•
>Yes<: modified parameters are accepted and saved.
•
>No<: parameter modifications are rejected and the instrument will exit the menus.
•
>Abort<: you will exit the prompt. Parameters remain to be modified, however will not
become effective and will not be saved.
Tip to repeatedly measure the same measurement places
If certain measurement places are to be measured not only once, but again and again it is
recommended to save the according parameter settings and readings (if required). This
eliminates the need to readjust parameters for the next measurement at the respective
measurement place by simply reloading the required data.
For more details see Sect. “31.1.9 Load” on page 49.
28.1 Save Parameters
Once all necessary (measurement place) parameters are specified, the data must be saved
in order to become effective.
Procedure:
1. Go “Back” three times: a window opens asking >Save Parameters?<. Confirm with
>Yes<.*
The message “Successful!” indicates that the parameters have been saved.
* >Yes< saves the new parameters; >No< will abort the saving process leaving the
last modified parameters active again; >Abort< will abort the saving process, the last
modified parameters remain active and the initialisation process can be continued.
28.2 Change WLAN Password
The WLAN password is set to an individually determined ID
per default
. This ID can be
found on a label on the side of the enclosure of the instrument.
The default password can be changed as described below. The new password must have be-
tween 8 and 32 characters.
Procedure:
1. Open the main menu with “Menu”.
2. Open the >WLAN< menu.
3. Select >Password<.
4. Enter the new password and confirm.
Up to four users may have access to transmitter and parameters simultaneously via WLAN.
Simultaneous access will not be indicated or logged.
Necessarily observe to agree parameter changes in order to avoid several users accessing
the parameters at the same time. Always the latest saving process applies.