Operation start-up
NivuFlow Stick - rev. 00 / 27.01.2020
Page 25
Operation start-up
23 Notes to users
Before connecting and operating the NivuFlow Stick the instructions below shall be followed.
This instruction manual contains all information required for the setting of parameters and for
the use of the instrument. The manual is intended for qualified personnel.
Read this instruction manual carefully in order to guarantee proper operation of the NivuFlow
Stick.
In case of doubt regarding installation, connection or the setting of parameters contact our
hotline:
•
+49 (0)7262 9191 955
General principles
Follow the hints in the instruction manual to eliminate the risk of faulty or incorrect setting of
parameters. Before you begin to set parameters, get familiar with the transmitter operation.
The user interface of the NivuFlow Stick is easy to understand. Users can make all required
basic settings themselves.
24 First steps
To set parameters and to use the NivuFlow Stick after unpacking just open the enclosure
cover and insert the rechargeable or standard batteries. After that, the connection to the ac-
cording smartphone, tablet, notebook or PC can be set up. Then, the parameters including
the definition of the batteries used according to Sect. “35 Battery (12V) Parameter Menu” can
be set. More parameters can be set depending on the respective measurement place.
See Sect. “26 Setting Up Connection” and “Parameter Setting”.
25 Indication System of Status LED on NivuFlow Stick
The status LED (Fig. 25-1) on the front side of the NivuFlow Stick follows a predetermined
system which indicates the current status of the instrument.
Fig. 25-1 LED on the NFS front
Once the NivuFlow Stick is in full working conditions without limitation the LED is lit
green
: 1x
long, pause, 5x short.
The same intervals apply as soon as there is
one
error message pending at least. The LED
then, however, is lit
red
.