30
Following is the procedure outline:
(1) Selecting constant selection mode
(2) Selecting Pn002
(3) Displaying the details of Pn002 constant
(4) Changing the set value to 2000
(5) Confirming the input
Display
Details
This section describes how to set a constant by giving an example of "Changing Pn002 constant
from "2500" to "2000" when the power supply is turned on".
Press the ENTER key to switch to the constant
selection mode.
The constant number portion will blink.
Press [>] key to change the desired digit (blinking
display).
* The digit to be changed is divided into the upper 1
digit and the lower 2 digits.
(2)
(1)
-
Press [
∧
] key until Pn002 is displayed.
5-3. Example of setting the constant
Press [
∧
] key. The display will switch to the constant
selection display.
* The 7 segment LED display as shown on the left
will appear when the constant number is Pn000.
Press [
∧
] key. The display will switch to the monitor
selection display.
* The 7 segment LED display as shown on the left
will appear when the monitor number is Un000.
Press [
∧
] key. The display will switch to the rotation
direction switching display.
* The 7 segment LED display as shown on the left
will appear when the rotation direction is CW.
It is a default display when the power supply is turned
on. Existing speed command is displayed.
* The 7 segment LED display as shown on the left
will appear when the speed command is 2500 [r/min].
Press [
∧
] key. The display will switch to the motor
speed display.
* The 7 segment LED display as shown on the left
will appear when the motor speed is 0 [r/min].
Press [
∧
] key. The display will switch to load factor
display.
* The 7 segment LED display as shown on the left
will appear when the load factor is 0%.
Procedure
No.
Operation