Max 8/16 and T1/E1 User’s Guide – Chapter 4
Page 25
as shown in Figure 12 below illustrating the Network
Configuration Table on the Network and Voice
Configuration page.
b. Change the UDP Start Port to the port you opened in
step 1-b above. For example, if you opened UDP Port
21000 in step 1-b, enter
21000
for the UDP Start Port
as illustrated in Figure 12 below.
Figure 12 – Network Configuration Table
3. Save your settings and restart the Max 8/16 or T1/E1:
After you have made the desired changes, click the Save
button at the bottom of the page to save the new settings,
then restart the unit.
The new settings should now be in effect.
NOTE: Some firewalls require the opened port to be
forwarded to the Max 8/16 or T1/E1’s IP address. Consult
your LAN administrator to determine if this is the case
with your firewall.
Port Identification with the Web Manager
The Web Manager makes it easy to determine which of the ports on
the Max 8/16 are FXO and which are FXS. The Configuration Manager
allows you to do this by referring to the Remote Access IVR
Configuration Table.
To go to the Remote IVR Access Configuration Table, click the
Remote IVR Config link on the Site Map page.
