Max 8/16 and T1/E1 User’s Guide – Chapter 2
Page 13
Baud rate
19200
Parity
None
Character size
8
Stop Bit
1
Flow Control
None
4. Power-on the Max 8/16 or T1/E1, then press the Enter key
on your PC.
The boot messages are displayed, followed by the command
prompt
n2p:>
.
NOTE: The unit is shipped with n2p as the default system
name. You can replace this with a system name that you
designate, such as
MY_Max:>
. To change the system name,
see System Information and Commands on page 45 in this
Guide.
5. Press the Enter key.
The Login: prompt is displayed.
6. Three default user IDs are provided:
•
root
•
manager
•
sysadm
7. Type one of these user IDs at the Login: prompt, and then
press the Enter key.
For example, type
root
, and then press the Enter key.
The Password: prompt appears.
8. At the Password: prompt, type the default password,
n2p
,
and then press the Enter key.
The command line prompt n2p:> appears. You are now
logged in.
NOTE:
Max 8/16 or T1/E1 provides three fixed user (or
manager) names.
You can change any manager’s password, but
managers cannot be created, deleted, or renamed.
Manager names and passwords are case sensitive.
Obtaining the Max 8/16 or T1/E1’s DHCP IP address via HyperTerminal
If your LAN uses static addresses, refer to Entering Static IP
Addresses via HyperTerminal (Max 8/16 and T1/E1). on page
15 of this Guide.
