Max 8/16 and T1/E1 User’s Guide – Chapter 2
Page 15
4. Hang up the telephone.
DHCP is now disabled.
Entering an IP Address from a Telephone Keypad
Ask your LAN administrator for the IP address that will be assigned,
the LAN’s netmask address, domain name, and any other IP
parameters that can be provided.
To enter the IP address:
1.
Lift the telephone handset and dial
***
2 (the IP address
parameter code).
The voice prompt responds, “Please enter your IP address.”
2. Dial the numbers for the IP address you wish to enter on the
telephone keypad. Use the star key (
*
) to replace the periods
in the address and end with the pound key (
#
).
3. For example, if you want to enter the IP address
192.168.172.19, you would enter
192*168*172*19#
from
your telephone keypad.
The voice prompt responds, “Your IP address is…” and repeats
the address you entered.
4. If the new address is correct, simply hang up the telephone.
If the new address is incorrect, hang up the telephone and
repeat from step 1, above.
5. Reset the Max 8/16 or T1/E1 to activate the changes. To do
this, power-off the unit, wait 10 seconds, and turn it on again.
DHCP is now disabled.
You are now ready to finish setting up the Net2Phone Max 8/16 using
the Max Web Manager. Proceed to Chapter 3, Logging Into the
Max Web Manager.
Entering a Netmask Address from a Telephone Keypad
To enter a netmask address:
1. Lift the handset and dial
***
3 (the netmask parameter
code).
The voice prompt responds, “Please enter your netmask.”
2. Proceed as in step 2, above, entering the desired netmask
address from the telephone keypad.
The voice prompt responds, “Your netmask address is…” and
repeats the address you entered.
3. If the new address is correct, simply hang up the telephone.
If the new address is incorrect, hang up the telephone and
repeat from step 1, above.
