Max 8/16 and T1/E1 User’s Guide – Chapter 1
Page 7
Installing the Max 8/16 and T1/E1
1. Install the unit in a well-ventilated area. If it is to be placed
on a surface rather than in a rack, be sure that all four rubber
feet are in place to allow for proper air circulation. Do not
place objects in excess of 20 pounds on top of the unit.
CAUTION: Please refer to the Net2Phone Max 8/16 and
T1/E1 Hardware Installation Guide and observe the safety
precautions listed.
2. Connect an analog telephone to any one of the FXS ports.
(Reminder: If you are not sure which port or ports are FXS
ports, refer to Identifying FXS and FXO Ports on page 5 of
this Guide.)
3. Connect the RJ-45 LAN port to a hub or switch.
4. Connect your FXS and/or FXO ports to your PBX as per the
illustrations in Figure 4 and 5, below.
NOTE: If no FXS ports are installed on the Max, initial LAN
configuration is done via a PC connected to the Max
through its serial port, using the HyperTerminal terminal-
emulator application (or equivalent), which is included
with all Microsoft
TM
operating systems. (This is optional
when FXS ports are present.) This procedure is explained
in Connecting to the Max 8/16 or T1/E1 Using
HyperTerminal on page 11 of this Guide.
