Max 8/16 and T1/E1 User’s Guide – Chapter 2
Page 17
The active directory changes to
/netutil
and the prompt
becomes
n2p:/netutil>
.
3. Type
dhset disable
and then press the Enter key.
4. Type
dhcpd disable
and then press the Enter key.
The Max 8/16 or T1/E1’s DHCP feature is now disabled.
5. Type
/SYS
to move to the system directory.
6. At the
n2p:/system>
prompt, type
reset
.
7. At the confirmation line, type
y
to proceed.
E
NTERING AN
IP A
DDRESS
To connect to the Max 8/16 or T1/E1 Web Manager, you will need to
enter at least an IP address and netmask. From the DOS prompt,
type:
/CONFIG/IP
to move to the IP configuration directory.
1. Type
change
to activate the interactive IP setting menu.
2. Type the number of the parameter you want to enter or
change.
3. At the
Enter <parameter>:
prompt, enter the desired value.
Example:
a. Enter 1 at the menu prompt to change the IP Address.
b. At the prompt, enter the IP address you wish to assign.
4. When you finish making changes, reset the Max 8/16 or
T1/E1 to activate the changes.
You may either:
•
Type
/system/reset
at the command line
OR
•
Power-off the unit, wait 10 seconds, and turn it on
again.
5. (Optional) Ping the Max 8/16 or T1/E1 from a PC, as
illustrated below, using the new IP address, to confirm that
the correct parameters have been entered and stored
successfully.
