NEC Express5800/340Hb-R N8800-047F, User Manual

Page: 259 / 312

Troubleshooting 7-15
"Stratus Fault Tolerant Virtual 69000 Video" is displayed on "Remove Hardware"
dialog box:
→
If you double-click an icon "Remove Hardware" on the system tray, two "Stratus
Fault Tolerant Virtual 69000 Videos" will appear. Do not remove them. Otherwise,
the connected PCI modules will be disconnected forcefully and the system may
operate normally.
Machine repeats rebooting at startup:
‰
Is CHKDSK executed at machine startup?
→
Open the utility of the BIOS setup at rebooting and change the following settings:
(Change BIOS settings)
Change [Stratus] - [Monitoring Configuration] - [Boot Monitoring] to [Disabled].
(For details, see Chapter 4.)
* After completion of CHKDSK, restart the machine and change the above setting
back to [Enabled] and continue the operation.
CHKDSK is executed in the following conditions:
(1) CHKDSK is scheduled to be executed at next system startup
(2) Corruption of file system is detected since the previous startup until shutdown
(3) Inconsistency (corruption) of file system is detected while mouting at system
startup
‰
Is the value of [Boot Monitoring Time-out Period] in the BIOS setting appropriate?
→
Change the value of [Boot Monitoring Time-out Period] to suit your environment.
(For details, see Chapter 4.)
Mouse does not move smoothly, and drawing graphics takes time:
‰
Is the hardware acceleration set to Full?
→
Set it to "None".
Make sure to set the hardware acceleration to None in NEC Express5800/ft series
(Default: None).
(How to check and change the hardware acceleration setting)
Select the [Start] - [Control Panel] - [Display] – [Settings] tab – [Advanced].
"Plug&Play Monitor and Stratus Virtual Video Properties" is displayed. Select the
[Troubleshoot] tab and check the hardware acceleration setting.