4-26 System Configuration
SCSI Device Settings
If you put the cursor on "SCSI Device Settings" with keyboard cursors (
↓
and
↑
) in the
"Configuration Settings" menu and press
Enter
, the screen for setting the information on the device
connected to the host adapter appears.
The table below shows the parameters of the setting items and their settings at shipment.
IMPORTANT:
The settings can be done in SCSI buses. The settings at shipment are the same
for both SCSI bus 0 and SCSI bus 1.
Submenu item Parameter
Description
Disconnects OK [Yes]
No*
Specify whether the disconnection of SCSI
devices from the SCSI bus is enabled or
disabled.
* "No" must be selected for ID8.
Check Parity
[Yes]
No
Specify whether the parity check is provided or
not.
Enable LUNs
[Yes]
No
Specify whether more than one LUN numbers
are given to SCSI ID.
Enable PPR
Yes
[No]
Leave this item as factory-set.
Enable Device
[Yes]
No
Leave this item as factory-set.
Negotiate Wide [Yes]
No*
Specify whether the wide (32 bits) transfer is
enabled or disabled.
* "No" must be selected for ID8.
Negotiate Sync
[Yes]
No*
Specify whether the synchronous transfer is
enabled or disabled.
* "No" must be selected for ID8.
Tagged Queuing [Yes]
No*
Leave this item as factory-set.
* "No" must be selected for ID8.
Sync Offset
00, 02, 04, 06, 08, 10, 12, 14,
16, 18, 20, 22, [24]
Select the proper offset value in synchronous
transfer.
Sync Period
[Ultra3 9
Ultra2 10
Ultra 12
Fast 25
40
= 160MB/s]
= 80MB/s
= 40MB/s
= 20MB/s
= 12.5MB/s
Select the proper speed in synchronous transfer.
Exec Throttle
1, 4, 8, [16], 32, 64, 128, 255 Leave this item as factory-set.
[ ]: Factory-set
Summary of Contents for Express5800/340Hb-R N8800-047F
