NEC ElectraElite IPK, Programing Manual

Page: 701 / 719

3 - 48 Advanced Applications
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
H
When bypassing LCR for CBC, press a line key assigned for RAB or Dial
the RAB access code to access the RAB. Using LCR requires dialing
1+NXX+NXX+XXXX. Pressing the RAB line key requires dialing
NXX+NXX+XXXX. The greater of the two should be registered in MB 1-
10-08 (Call by Call Max Digit Assignment).
LCR should be assigned to delete the 1. It should not be sent to the
network.
H
The system sends the number dialed to the network by the earliest
occurrence of the following. Either the Max digits assigned by MB 1-10-
08 (Call by Call Max Digit Assignment) are reached or the ISDN Dial
Interval Time assigned by Memory Block 1-1-81 (ISDN Dial Interval Time
Selection) expires.
H
An incoming call is regarded as DID, but if called party information is not
sent as for FX, it is regarded as a normal incoming call. Day/Night Ring,
using Memory Block 4-01[CO/PBX Ring Assignment (Day Mode)]/
Memory Block 4-02[CO/PBX Ring Assignment (Night Mode)], or DIT/
ANA, using Memory Block 3-61 (DIT/ANA Delay Answer Time
Selection), must be set for all COs.
H
CBC parameters can be set to all assigned values. When an unused
value is set, outgoing calls may not process properly.
H
The Type of Network ID (TNI), Network ID Plan (NIP) and Network ID
(NID) are mutually related. When NID is not registered, TNI, NIP, and
NID are not sent. When NID is registered, the registered values for NIP
and TNI are sent.
H
Main Software controls the incoming SFG as follows:
H
The Facility Coded Value (FCV), NID, and Service parameters are
extracted from the NSF-IE.
H
The RAB based CBC values are searched for a match.
H
When a match is found, the assigned SFG value for the RAB is used.
H
When a match is not found, software uses SFG value of 16.
H
When an incoming call indication is received, and the call is processed,
the counter for incoming calls is incremented by one.
H
When an outgoing call is processed, the counter for incoming calls is
incremented by one.
H
When the call is terminated before sending a SETUP message to the
network, the outgoing call is canceled and the call counter is decreased
by one.