NEC ElectraElite IPK, Programing Manual

Page: 160 / 719

Elite IPK Document Revision 1
Programming Manual 2 - 89
___________________________________________________________________________________
___________________________________________________________________________________
1-1-78 Caller ID Display Assignment for
System Mode
General Description
Use this Memory Block to assign up to 15 Multiline Terminals to display ANI/Caller ID
Indication for normal incoming CO/PBX calls or CO/PBX calls ringing a Call Arrival
(CAR) key.
Display
Notes
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
GH
to access the Memory Block.
3 Use the dial pad to enter Entry No. 01 and Tel Port No.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
Default Values
Not specified
4 Press
G
to write the data and advance to the next Entry No. After each tel port No. is selected, press
G
again. A
total of 15 entries can be made. After the last data is entered, the next Memory Block is displayed.
5 Program the next Memory Block or press
E
to go back on-line.
1. To display ANI/Caller ID Indication for normal incoming and CAR incoming calls, Caller ID Indication and Ring
Assignment must be programmed.
2. Fifteen Multiline Terminals can be assigned system-wide to display ANI/Caller ID.
3. A sixteenth terminal can be assigned to display ANI/Caller ID using another Memory Block.
System Mode
1
Submode
1
Data No.
78
PC Programming
¦
+AI
7 8 : C A L L I D 0 1 =
T I M E D I S P L A Y
Data
No.
Entry
No.
01~15
Title
Tel Port No.
(00~99
A0~A9
B0~B9
CO)