NDC BenchMike Pro, Instruction Handbook Manual, Page: 101 / 146

BenchMike Pro 2025/2050 & Z-Mike Pro 4025/4050 Instruction Handbook: Advanced Capabilities 5-3
5.1.1.4 Reserved Variable Names
Each feature contains a list of reserved variables, as listed in the following table. These variable names follow the
format:
fn.xxx
where n is the feature number and xxx is the reserved variable name.
For example, the size variable for feature #1 is f1.size, and the deviation variable for feature #20 is f20.dev.
Variable Description
average SQC average
count SQC count
dev Deviation from nominal
diff SQC difference (maximum - minimum)
good Count of “good” measurements (limits)
lrlim Lower reject limit (-reject)
lrtol Lower reject tolerance (-reject)
lwlim Lower warning limit (-warning)
lwtol Lower warning tolerance (-warning)
max SQC maximum
min SQC minimum
nominal Nominal size
over Count of “over” measurements (limits)
pos Position in measurement area
pos.offset Position in measurement area “offset”
sd SQC standard deviation
size Measured size
size.offset Measured size “offset” (single point master)
under Count of “under” measurements (limits)
urlim Upper reject limit (+reject)
urtol Upper reject tolerance (+reject)
uwlim Upper warning limit (+warning)
uwtol Upper warning tolerance (+warning)