Motorola BSR 2000, Configuration And Management Manual

Page: 67 / 650

Release 1.0 Configuring the System
526360-001-00 Rev. B MGBI 3-17
Restricting Logging Rates
You can restrict logging rates to save space on a device and ensure that there is no
network performance degradation due to excessive logging traffic. Logging rates can
be restricted for both CLI and DOCSIS logging control modes. When the rate of
logging messages exceeds the configured rate limit, logging activity is disabled and
must be restarted.
To restrict the rate of log messages, specify the number of logged messages allowed
per number of seconds with the
logging rate-limit command in Global configuration
mode:
MOT
(config
)#
logging rate-limit <
0-2147483647
> <
1-2147483647
>
where:
0-2147483647
is the number of messages.
1-2147483647
is the number of seconds at which the specified number of
SYSLOG and trap messages are logged.
trap disabled
SYSLOG disabled
Table 3-4 DOCSIS Logging Default Destination/Severity Levels
Destination Default Severity Level
console disabled
log buffer (local) notice or higher
trap notice, warning, error, critical
SYSLOG notice, warning, error, critical
Note: Rate limiting applies to all log messages and can not be restricted for a
particular type of log message.
Table 3-3 CLI Logging Default Destination/Severity Levels