Motorola BSR 2000, Configuration And Management Manual

Page: 317 / 650

Release 1.0 Configuring the CMTS
526360-001-00 Rev. B MGBI 6-131
■
When you modify a CM’s configuration file and specify parameter values that are
already in use by other registered modems and fail to change the class of service
ID to a unique value.
However, all registered CMs are using the class of service (QoS) parameters as
defined in their respective configuration files, only the displayed output of the
show
cable qos profile command that is inconsistent.
Once all DOCSIS 1.0, DOCSIS 1.0+, and Euro-DOCSIS 1.0 classes of service have
unique classIDs, the display of the
show cable qos profile command is accurate.
Configuring the BSR 2000 for DOCSIS 1.0+ Interoperability
In order for the BSR 2000 to register DOCSIS 1.0+ cable modems successfully, the
BSR 2000 must be configured to accept and process DSA-REQs from DOCSIS 1.0+
devices.
Follow these steps to configure the BSR 2000 for interoperability with DOCSIS 1.0+
cable modems.
1. Use the config command to enter Global Configuration mode.
MOT#
config
The prompt changes to
MOT
(config)
#
indicating that the CLI is accepting
commands in Global Configuration mode.
2. Use the interface cable command to select the cable interface from Global
Configuration mode.
MOT
(config)
#
interface cable <
X
/
Y
>
where:
X
is 0.
Y
is the port number.
3. Use the cable dynamic-service authorization-mode unauthorize command
from Interface Configuration mode to allow the cable interface to accept
DSA-REQs from DOCSIS 1.0+ cable modems.
MOT
(config-if)# cable dynamic-service authorization-mode unauthorize
After issuing the command, a message similar to the following is displayed on the
console.