Motorola BSR 2000, Configuration And Management Manual

Page: 423 / 650

Release 1.0 Configuring PacketCable
526360-001-00 Rev. B MGBI 7-27
■
Issue the es trap-enable command to enable or disable the electronic
surveillance SNMP trap:
MOT (config-pktcable) #
es trap-enable { disable | enable }
where:
disable disables the electronic surveillance SNMP trap.
enable enables the electronic surveillance SNMP trap. The default is
disabled.
Issue the following commands to clear electronic surveillance information:
■
Issue the clear packet-cable statistics es identifier command in Privileged
EXEC mode to clear
duplicated packet and byte counts
:
MOT#
clear packet-cable statistics es identifier {<
0x00000000-0xffffffff
>}
where:
0x00000000-0xffffffff
optionally clears a specific ES identifier.
■
Issue the clear configuration es command in PacketCable Configuration mode
to clear electronic surveillance SNMP traps and reset es trap-enable to
"disabled".
Displaying Electronic Surveillance Information
Use the following commands in all modes except User EXEC mode to display
electronic surveillance information. Refer to the
BSR 2000 Command Reference
Guide
for detailed command output information.
■
Issue the
show packet-cable configuration es command
to
display
electronic
surveillance
configuration information.
Note: Electronic surveillance conforms to Communications Assistance for
Law Enforcement Act (CALEA) requirements.