Motorola BSR 2000, Configuration And Management Manual

Page: 92 / 650

BSR 2000 Configuration and Management Guide Release 1.0
3-42 MGBI 526360-001-00 Rev. B
1-1000
is the wait time interval in seconds. The default value is 5 seconds.
Configuring a Loopback Interface for RADIUS Packets
The radius-server source-interface loopback command allows an operator to
control the source IP address of RADIUS authentication protocol packets generated
by the BSR by specifying a loopback interface as the source IP address for RADIUS
authentication protocol packets. The normal convention for generated RADIUS
authentication protocol packets is to set the source IP address equal to the IP address
of the outgoing interface. Use the
radius-server source-interface loopback
command in Global Configuration mode to override this convention and instead use
the IP address as shown below
:
MOT(config)#
radius-server source-interface loopback <
1-64
>
where:
1-64
is the loopback interface number
Configuring RADIUS Client Access
Before you configure RADIUS client access parameters, ensure that user password
parameters are configured on the BSR 2000 and the RADIUS server. Refer to
Accessing the CLI to Set System Passwords on page 3-3 for more information.
Use one or more of the following options to enable and configure the RADIUS Client
feature:
1. Use the telnet authentication radius command in Global Configuration mode to
enable RADIUS client authentication for telnet session access to the BSR:
MOT(config)#
telnet authentication radius [ local-password ]
where:
Note: Before using the radius-server source-interface loopback
command, the loopback interface must be configured and assigned an IP
address.
Note: User password attributes in the RADIUS request sent from the
RADIUS client on the BSR to the RADIUS server are encrypted.