Motorola BSR 2000, Configuration And Management Manual

Page: 427 / 650

Release 1.0 Configuring PacketCable
526360-001-00 Rev. B MGBI 7-31
Figure 7-12 displays typical show packet-cable configuration dqos command
output:
Figure 7-12 Output for the show packet-cable configuration dqos Command.
Configuring DQoS Parameters
Follow the procedures in these sections to configure DQoS parameters:
■
Configuring DQoS Gate T0 and T1 Timers
■
Displaying Gates
■
Displaying Gate Statistics
Configuring DQoS Gate T0 and T1 Timers
The DQoS Gate Timers have default parameter settings associated with them and they
do not have to be configured. If T0 and T1 timeouts are being counted in the
show
packet-cable statistics gate command output, the network and the PDP server need
to be examined. T0 and T1 timers may need to be increased from their default values
to avoid T0 and T1 timeouts.
■
The BSR considers the assigned gate ID to be invalid when the DQoS Gate Timer
T0 timer expires.
Issue the dqos t0-timer command in PacketCable Configuration mode to limit
the period of time that a gate can be allocated without the gate parameters being
configured:
MOT(config-pktcable)#
dqos t0-timer <
1-3600
>
where:
1-3600
is the timer value in seconds. The default is 30.
MOT(config-if)#show packet-cable configuration dqos
Dynamic QoS Configuration
-------------------------
DQoS is enabled
T0 Timer: 30 seconds
T1 Timer: 60 seconds
Resource Request trap: disabled
Emergency trap: disabled