Configuration and Troubleshooting
2-88 Manual # 42-02-2P26
Stuck Safe Edge (160)
Safe edge input continuously active. If Bypass Stuck Safe Edge (Config
01) is enabled, the controller will ignore the SE and close the doors after
the Stuck SE Timer elapses or when the Car Delayed timer expires,
whichever comes first. Fault-bypassed in Construction/Inspection.
System Verifies:
- Door Flags, Stuck Safe Edge Timer = Elapsed
- Door Flags Safety Edge Bypassed and Safe Edge Failed are not true.
Correction:
1. Verify Safe Edge status, System IO > Programmed Inputs.
2. If no Safe Edge is installed, input should not be programmed.
3. Verify function of Safe Edge device.
Stuck Sensor (Edge) (219)
Initiated by the LS-EDGE-EL landing system. A leveling or terminal sen-
sor is not changing state. Fault-bypassed in Construction/Inspection.
Correction:
1. Verify the LED indicators (UTILS > LS View) show state changes while
traversing door zones, ETS, or Terminal magnets.
2. Replace LS-EDGE-EL tape reader.
Stuck Up Hall Call (356)
System has detected a sticking up hall call button.
Suspension Integrity (1)
Traction Only. With alternate suspension materials (belts, non-steel
ropes, etc.), a sensor is required to monitor integrity of suspension
means. Fault is triggered by an active input from that sensor. Car will
stop at the next floor, cancel all calls, and cycle doors to allow passengers
to exit, and shut down. Fault-bypassed in Construction. Manual reset
required.
System Verifies:
- SMI input is configured.
- SMI input is low.
Correction:
1. If in error, check that an input is not mistakenly programmed for this
function (System IO > Programmed Inputs, SMI input). If so, set to
unused.
2. If valid, verify sensor and suspension integrity.
Terminal Switch Learn (386)
A terminal switch learn operation is in progress.
Terminal Sync (Edge) (222)
Initiated by the LS-EDGE-EL landing system. Indicates that the landing
system has lost position and is performing a terminal synch operation.
Fault-bypassed in Construction.
Test Mode (3)
The controller is operating in Test Mode. This mode allows the car to be
run at contract speed with door opening disabled to facilitate testing. Hall
calls are not registered. Fault-bypassed in Construction/Inspection.
System Verifies:
- Mode of operation = Test
Correction:
1. If Test mode is not selected, check System IO > System Inputs, Test.
2. Verify Test/Pretest switch not in Test position.
Top Deviation (Edge) (221)
Initiated by the LS-EDGE-EL landing system. LS-EDGE-EL encountered
terminal magnets that do not match the learned positions. Fault-
bypassed in Construction/Inspection.
Correction:
1. Verify magnets for terminals have not been changed.
2. Relearn terminal magnet locations (Utils > Landing System Utilities >
Terminal Switch Learn).
Table 2.15 Touch Screen Event Listings
Event
Description
