ii) Offset Cantilever Arm Height Adjustments:
If desired, the left & right cantilever armrest can be offset from each other by up to
1.5” (38mm)
. (
Adjustments
are available in
3/4”(19 mm)
increments).
1. To offset the armrest heights, first adjust the higher armrest height to the desired position on the tilt back
cane (as per the instructions in section
i) Combined Arm Height Adjustment
).
2. To complete the offset adjustment, it will be necessary to disassemble the spreader bar hardware (
1
) from
one (or both) of the cane clamp assemblies
(1 screw per side).
3a. For a
3/4” (19mm)
Offset
(not shown)
: remove the spreader bar hardware only from the armrest being
lowered; Loosen the cane clamp assembly (3 screws) for the applicable armrest; Slowly lower the armrest
(cane clamp assembly) until the
upper
hole in the rear cane clamp mount is aligned with the spreader bar;
Reinstall the spreader bar mounting hardware and re-tighten the cane clamp hardware.
3b. For a
1.5” (38mm)
Offset
(illustrated below)
: remove the spreader bar hardware from both armrests;
reinstall the spreader bar into the
lower
hole on the rear cane clamp mount for the upper armrest (
2
);
Loosen the cane clamp assembly (3 screws) for the armrest being lowered; Slowly lower the armrest
(cane clamp assembly) until the
upper
hole in the rear cane clamp mount is aligned with the spreader
bar (
3
); Reinstall the spreader bar mounting hardware and re-tighten the cane clamp hardware.
4. Upon completing the adjustments, verify that all cane clamp and spreader bar mounting hardware is fully
re-tighten.
spreader bar
mounting hardware
1
spreader bar assembly
3
1.5” (38
mm
) offset
configuration shown
2
SIDE VIEW
cane clamp ass’y
rear cane
clamp mount
upper armrest
lowered armrest
upper armrest
(3/4” (19mm) increments)
Offset Armrest Configuration
REAR VIEW
Standard (Level) Armrest
Configuration
1.5
” (
38
mm
)
5.0
5.0
SEATING ACCESSORIES & COMFORT ADJUSTMENTS
SEATING ACCESSORIES & COMFORT ADJUSTMENTS
- 55 -
Summary of Contents for ULTRA-LOW MAXX UPFRONT MPPS
Page 99: ......
