5.0
5.0
SEATING ACCESSORIES & COMFORT ADJUSTMENTS
SEATING ACCESSORIES & COMFORT ADJUSTMENTS
5.1.2 SWING-AWAY QUAD LINK JOYSTICK MOUNT
C-Clip
Joystick not shown
ii)
J
OYSTICK
H
EIGHT
A
DJUSTMENT
(Q
UAD
-L
INK
M
OUNT
):
The
C-Clips
on the joystick mount may be re-arranged as
needed to adjust the final joystick height. (Each clip provides
1/4” (6 mm) of height adjustment- up to a max. 1” (25 mm)).
• Carefully remove/pry the clips from their existing position
using a small screwdriver or your finger tips.
• Re-insert the clips above or below each linkage
*
, as required
to attain the desired joystick height.
Linkage
i)
O
PERATING THE
M
ANUAL
S
WING
-A
WAY
F
EATURE
:
The swing-away feature allows easy repositioning of the Joystick
for client comfort, transfers, or environmental access.
• To use the swing-away feature, push outward on the joystick
in order to release the detent pins on the quad link mechanism
and rotate the joystick around to the outside of the arm pad.
• To return the joystick back to its original position in front of
the arm pad, rotate the joystick forward until the quad link
mechanism (detent pins) ‘click’ back into place.
*NOTE
: All lower clips (below linkage) must be installed prior to the
upper clips. Always adjust clips equally on both links.
arm pad
arm pad
WARNING! Risk of Injury or damage due to improper set-up/adjustment
• ALWAYS test the swing away joystick over its full range of motion to ensure there is no interference.
• ALWAYS ensure the height of the joystick is properly adjusted to prevent accidental contact between
the joystick knob and the arm pad (which could cause the wheelchair to move unexpectedly)
NOTE:
The Cell Phone Holder is an optional accessory designed for use exclusively with the ROVI-X3
wheelchair powerbase in combination with the USB charger port.
(
Note:
the USB Charger Port comes
standard with all Rovi-X3 wheelchair powerbases)
5.2.1 CELL PHONE HOLDER INSTALLATION:
WARNING! Risk of Damage to your Cell Phone/Electronic Device
The spring loaded holder is designed to safely secure most standard sized cell phones or electronic
devices (over
2”(51
mm
)
wide), when operating under normal operating conditions:
• ALWAYS ensure your cell phone/device is properly seated and secured inside the holder before driving
your wheelchair or operating your power positioning system;
• ALWAYS remove your cell phone/device from the holder and store in a secure place when travelling on
uneven or rough terrain. Failure to do so may result in damage to your cell phone or electronic device.
The cell phone holder is mounted directly to the USB Charger and secured to wheelchair via the charger mounting
bracket.
(
Note:
The cell phone holder may be mounted/positioned to the left or right side of the Joystick Control).
The charger bracket is secured between the joystick control and the joystick mounting plate using the existing
hardware.
(see
Installation Overview
below)
- 48 -
5.2 Cell Phone Holder
Summary of Contents for ULTRA-LOW MAXX UPFRONT MPPS
Page 99: ......
