- 91 -
Task
Delivery
Monthly
Periodically
6 Months
(Service)
Batteries
Load test batteries (individually)
X
X
Ensure batteries are clean (free from corrosion/ moisture/ dirt)
X
X
Ensure connections are tight and clean
X
X
Electrical / Wiring Harnesses
Check wire routing & cables for pinching or pulling
(over the full range of
seating system functions)
X
X
X
Inspect for wear & tear damage to wires/connectors
X
X
X
Ensure electronic connections are secure
X
X
X
Actuators
(where applicable)
Ensure actuator rod ends are properly pinned (if applic)
X
X
Ensure no interference/binding during system operation
(test all seating
functions over their full range of travel)
X
X
X
Inspect/listen for excessive motor noise or grinding
X
X
X
Hardware and Components
Inspect mounting interface hardware
(seating system to powerbase)
X
X
X
Inspect all adjustment hardware, and accesory hardware to ensure fasteners
are secure (e.g.; back canes, recline module, legrests/foot plates/receivers,
calf pads, armrests, arm pads, laterals, hip guides, etc...)
X
X
X
Inspect/listen for loose parts/rattling- ensure all fasteners are secure
X
X
X
Inspect that all pivot points are secured (do not overtighten) and operating
smoothly/freely (lubricate as needed)
X
X
X
Inspect Anti-Dive/Anti-Tip devices to ensure they are functioning correctly*
and inspect for damage.
(*refer to powerbase owners manual)
X
X
X
Limit Switches
Ensure electronic anti-tip latch system functions properly (for applicable
powerbases only)-
see also Power Base Owners/Operators Manual)
X
X
X
Check all safety lockouts and limit switch settings
X
X
X
Ensure DLO functions correctly
X
X
X
Pivots and Slide Channel Maintenance
Ensure slide channels are free from dirt/ dust/ grime
X
X
Lightly lubricate main pivot points, using a general purpose oil
(see Section
7.3 - Lubrication)
X
X
General
Clean/wipe down cushion and back upholstery and arm pads
(avoid the
use of bleach and harsh solvents that may damage upholstery))
X
Ensure upholstery does not have any rips or tears.
X
X
Inspect the postural (seat positioning) belt for any signs of wear. Ensure
the buckle latches, and verify that the belt/strap mounting hardware is secure
and undamaged
X
X
X
7.0 GENERAL SET-UP AND MAINTENANCE
7.0 GENERAL SET-UP AND MAINTENANCE
7.2 Maintenance Inspection Checklist
Summary of Contents for ULTRA-LOW MAXX UPFRONT MPPS
Page 99: ......