Mitsubishi Electric Q06CCPU-V, User Manual

Page: 221 / 618

6
PREPARATORY PROCEDURES AND SETTING
6.1 Handling Precautions
6
- 3
1
O
V
ER
VI
E
W
2
SY
STEM
CONFIGURA
TION
3
SP
ECIFICA
T
IONS
4
FUNCTIONS
5
A
C
C
E
SS V
IA
N
E
TW
OR
K
MODUL
ES
6
P
R
EP
AR
A
T
OR
Y
PROCE
DUR
ES
A
ND
S
E
TTING
7
I/O NUM
BER
ASS
IGN
M
EN
T
8
M
E
M
O
RIE
S
A
ND
FI
L
E
S
POINT
Referring to the following manual, observe the proper mounting procedures.
QCPU User's Manual (Hardware Design, Maintenance and Inspection)
• The case of the C Controller module is made of resin.
Do not drop or apply strong shock to it.
• Do not remove the printed-circuit board of the module from the case.
Doing so may cause failure.
• Tighten screws such as a module fixing screw within the following ranges.
3
* 1 The module can be easily secured to a base unit by the hook on the module top. However, it is
recommended to fix it with the module fixing screw in a place of frequent vibrations.
• Use the dummy CompactFlash card installed before shipping if necessary.
Do not insert a dummy CompactFlash card with no "A" printed (Figure 6.1) into a
module whose serial number (first four digits) is "1008" or later. Doing so may
make the card removal difficult, causing damage to the CompactFlash card slot.
A dummy CompactFlash card with "A" (Figure 6.2) is pre-installed in a module
whose serial number (first four digits) is "1008" or later.
Table 6.1 Tightening torque ranges
Screw
Tightening torque
range
Remarks
Module fixing screw (normally not required) (M3 screw)
*1
0.36 to 0.48N•m
RS-232 cable connector screw (M2.6 screw) for
Q12DCCPU-CBL and Q06CCPU-V(-B)
0.20 to 0.39N•m
Depth of screw hole:
L=3.2mm (0.13 inches) or less
(Internal length from the surface)
Figure 6.1 Dummy CompactFlash card
(without "A")
Figure 6.2 Dummy CompactFlash card
(with "A")
Not chamfered
Not chamfered
Not chamfered
"A" is not printed.
Chamfered
"A" is printed.
Chamfered
Chamfered