Mitsubishi Electric F930GOT-BWD-E, User Manual

Page: 257 / 274

Graphic Operation Terminal F930GOT Additional Functions (in V.2.00 or later) 13
13-9
13.3.2 Setting of communication
• Setting of RS-232C (channel 0) parameters
Set the system mode driver (DF1) to "half-duplex slave (DF1)".
Set other parameters to the default values (initial values).
• Channel configuration of DF1 (half-duplex slave)
Set the parameters as shown in the table below.
Set all parameters except shaded ones to the default values.
• Setting on the GOT side
When the connected PLC is set to "SLC500 Series" in the screen creation software or "SET-
UP MODE" in the GOT, the following setting is selected.
(The following setting is automatically selected when the PLC model is set to "SLC500
Series". You do not have to set them manually.)
Parameter Set value
Diagnostic File

Baud Rale 19200
Parity Even
Duplicate Packet Delection Disabled
Station Address 0
Error Delection BCC
Poll Timeout 50
RTS Off Delay 0
RTS Send Delay 0
Message Retries 3
Control Line No Handshaking
EOT Suppression No
Baud rate
19200
Data length
8 bits
Stop bit
1 bit
Parity bit
even
Control method
None