MIMAKI CF3-1610, Operation Manual

Page: 141 / 166

Adjusting the Tools
6-7
6
Tr
ou
bleshoo
ting
7
Press to make further adjustments.
Press to save the adjusted values and exit.
• To make further adjustments, press to display the adjustment screen.
Adjust Angle of
θ
: Operations from Step 4 on P.6-8.
Offset Adjustment : Operations from Step 4 on P.6-4.
• Press to exit without saving the adjusted values.
Adjusting the Eccentricity
The eccentricity can be adjusted on the screen below.
(1) Check the position of the horizontal line with respect to the vertical lines on Pattern A.
• Check if the horizontal line protrudes or if there are gaps.
(2) Check if the X and Y axis lines in Pattern B form straight lines.
(3) Make the adjustment.
Adjusting Pattern A Adjusting Pattern B
• When using the 2° carbide reciprocating cutter, adjust
the horizontal line to protrude approx. 2 mm.
< AD J > CENT ER 1 / 3
A ( L ENG ) + 0 0 . 0 0 >
B + 0 0 . 0 0 >
T ES T PA T T ERN - >
Adjusting Pattern A
Aligns the center of the cutter (roller) with
the center of the holder.
Press or to adjust.
(0.05 mm pitch)
Adjusting Pattern B
Adjustment to check whether the tool is tilted.
Press or to adjust.
(0.05 mm pitch)
Gap
Measure distance A on the diagram.
Press to adjust in the negative
direction to Set value = +A.
Line protrudes
Measure distance A on the diagram.
Press to adjust in the positive
direction to Set value = -A.
Top line displaced to the left
Press to adjust in the negative direction
to Set value = (length B in diagram) / 2.
Top line displaced to the right
Press to adjust in the positive direction
to Set value = (length B in diagram) / 2.