MIMAKI CF3-1610, Operation Manual

Page: 80 / 166

2-24
Crease Roller (Model TF2 or Model R1)
Swivel Blade (Model TF2 or Model R1)
Check Point Cause Remedy See page
Point A contact points do not
match Blade is mounted eccentrically Conduct Adjust Eccentricity in tool
adjustments.
P.6-6
Lines displaced at Point A Abnormal angle
θ
of crease roller Conduct Adjust
θ
in tool adjustments. P.6-8
Crease is weak Press value low Increase the “PRESSURE” in the
cutting conditions.
P.2-12
Crease roller for corrugated
cardboard is used on coated
board. Use a crease roller for coated board.
Crease lines torn along flutes
of corrugate cardboard. Y PRESS value in the cutting
conditions is too high. Align the corrugated cardboard flutes
in the Y-axis direction.
Decrease the “Y PRESS” in the
cutting conditions.
P.2-12
Check Point Cause Remedy See page
Broken lines Swivel cutter incorrectly mounted. Fully tighten the holder screw. P.1-19
Speed is too slow. Increase the “SPEED” in the cutting
conditions.
P.2-12
Press value low Increase the “PRESSURE” in the
cutting conditions.
P.2-12
Corners rounded off The blade does not protrude
enough. Increase the amount that the blade
protrudes.
P.2-18
Offset value is too small. Increase the “OFFSET” in the cutting
conditions.
P.2-12