MIMAKI CF3-1610, Operation Manual

Page: 158 / 166

6-24
Making an DATA DUMP
1
Use the Tool Select function to set the tool to pen. ( P.2-8)
2
Position A3 or larger paper in landscape direction.
3
Set ORIGIN at the left edge of the paper.
(
P.2-31)
4
Display the third page of the local menu.
• Press several times.
5
Press and select
[SELF TEST].
6
Press and select
[DATA DUMP].
7
Press .
• The tool moves to the upper-left corner of the paper.
8
Check the paper position.
• Check that the pen tip is at the upper-left corner of the paper.
• If the pen tip is not located at the upper-left corner of the paper, align the upper-left corner of the
paper with the pen.
9
Press to make the DATA DUMP.
• The unit draws the communications conditions.
• An DATA DUMP is not possible for Model M.
• The ASCII dump requires a pen and A3 or larger paper.
• If paper smaller than A3 is used, the drawing may extend outside the paper.
• When ASCII dump is set, the tool automatically changes to pen. Ensure that a pen is mounted in Unit A.
[ LOCA L ] 3 / 5
I NT ERF ACE - - - >
MODE SE T - - - >
SE L F T EST - - - >
< SE L F T ES T > 1 / 5
PAT T ERN CUT 1 - - - >
PAT T ERN CUT 2 - - - >
DAT A DUMP
- - - >
<DA T A DUMP > 1 / 1
END KEY t o S T ART
CE KEY t o CANCE L
<DA T A DUMP > 1 / 1
A 3 LOCA CONF I R >
* UPPER L E F T SE T
* MARG I N 1 0 * 1 0mm