MIMAKI CF3-1610, Operation Manual

Page: 71 / 166

2-15
Setting the Cutting Conditions
2
Bas
ic Operations
Outline
Speed of tool movement in the X or Y direction. Changes according to the type of tool and workpiece and the data size.
Pressure when cutting the workpiece with a press tool.
Maximum tool acceleration. Changes according to the type of tool and workpiece and the data size.
Offset for cutting start position when the tool descends. When cutting a thick workpiece, setting this offset to a large value cuts from
the front of the workpiece to simplify separation.Adjust this setting while checking the finish.
Offset for cutting end position when the tool ascends. When cutting a thick workpiece, setting this offset to a large value makes an
extra cut from the end position that simplifies.Adjust this setting while checking the finish.
Sets the minimum angle to raise the cutter and change the direction, when changing the cutting (crease) direction. This reduces the
degree of damage to the workpiece by the tool.
Sets the rounding radius (R) and adds a line segment between segments for a consecutive series of line segments. This reduces
the degree of damage to the workpiece by the tool.
Corrects the tool downwards pressure when cutting (crease cutting) a thick workpiece. Applying the PRESS COR value to the
previously set press value ensures satisfactory cutting when the tool descends.
Corrects the press value in the Y-axis direction to allow crease cutting with a different pressure to the X-axis direction. When crease
cutting corrugated cardboard, position the corrugated cardboard with the flutes in the Y direction to cut with a lighter pressure than
in the X direction.
This is the offset value for the tip of the swivel blade cutter. Change the setting according to the workpiece thickness and wear of the
cutter blade.
Sets the oscillation speed in 5 steps. Normally, set this item to 4 or 5. Reduce the oscillation speed for a heat-sensitive workpiece.
Set OFF when using cutter holder 2N.