![background image](http://html.mh-extra.com/html/miele/advanta-g-2170/advanta-g-2170_technical-information_234506216.webp)
Technical Information
216
G 1xxx/G 2xxx
until the "Start/Stop" LED flashes.
5. Release the
Start/Stop
button.
6. If the "Start/Stop" LED does not light up, repeat the procedure.
Acknowledgement indicator:
The "Start/Stop" LED flashes slowly (1 flash per second).
Options:
Function Programming
Display
Software version ID check
Do not press the
Delay
Start
button. The “Delay
Start” LED is not lit.
"Rinse" LED is out or flashes. The
display shows the software version
ID no. in consecutive digits
(e.g., -
818
).
Display and delete fault
memory
Press the
Delay Start
button once. The "Delay
Start" LED flashes once
quickly intermittently.
Press the
Start/Stop
button. Press it again to
display faults that may
have been saved. To
delete the fault memory,
press the
Start/Stop
button again and hold for
4 s.
The "Rinse" LED is off or flashes.
The display shows
F
and a fault
code number alternately (for a list of
fault codes, see Table 080-2). If the
fault memory is empty,
F
and
0
are
displayed alternately.
Component test
Press the
Delay Start
button 2x. The “Delay
Start” LED flashes 2x
quickly intermittently.
Press the
Start/Stop
button. Press it again to
activate the next
component.
The display shows which
component is being tested. For
example, if drain pump M8 is being
tested,
U
and
3
are shown
alternately. For the test sequence
and background information about
individual components and their
activation, see Section 080-2.2.
Operating hours check
Press the
Delay Start
button 3x. The “Delay
Start” LED flashes 3x
quickly intermittently.
The display shows the number
of operating hours as follows: If the
appliance has run for 74 hours,
h
,
7
and
4
are displayed alternately.
LED test
Press the
Delay Start
button 4x. The "Delay
Start" LED flashes 4x
quickly intermittently.
Press the
Start/Stop
button once.
The display shows
6.1
. All LEDs
light up.
Table 080-39:
Service Mode Summary, G 2420/G 243x
4.3.9
Excella - G 2630/G 2670
Initial
requirements:
1. Close the door (open for G 2670).
2. Switch off the appliance.
Accessing:
1. Press and hold the
C (clear)
button.
2. Switch on the appliance.
Summary of Contents for ADVANTA G 2170
