![background image](http://html.mh-extra.com/html/miele/advanta-g-2170/advanta-g-2170_technical-information_234506212.webp)
Technical Information
212
G 1xxx/G 2xxx
Options:
Note:
In models with software version ID –769, wait for the decimal point in the
display to switch off before pressing the
GEL
button.
.
Function Programming
Display
Software version ID check
Do not press the
GEL
button. The “GEL” LED is
not lit.
The display shows the software
version ID no. in consecutive digits
(e.g., -
818
).
Display and delete fault
memory
Press the
GEL
button
once. The "GEL" LED
flashes once quickly
intermittently. Press the
Program
button. Press it
again to display fault
codes that may have been
saved. To delete the fault
memory, press the
Program
button again and
hold it for 4 s.
The display shows
F
and a fault
code number alternately (for a list of
fault codes, see the service
manual). If the fault memory is
empty,
F
and
0
are displayed
alternately. See Table 080-2 for a
list of fault codes.
Component test
Press the
GEL
button 2x.
The “GEL” LED flashes 2x
quickly intermittently.
Press the
Program
button. Press it again to
activate the next
component.
The display shows which
component is being tested. For
example, if drain pump M8 is being
tested,
U
and
3
are shown
alternately. For the test sequence
and background information about
individual components and their
activation, see Section 080-2.2.
Operating hours check
Press the
GEL
button 3x.
The “GEL” LED flashes 3x
quickly intermittently.
The display shows the number
of operating hours as follows: If the
appliance has run for 74 hours,
h
,
7
and
4
are displayed alternately.
LED test
Press the
GEL
button 4x.
The "GEL" LED flashes 4x
quickly intermittently.
Press the
Program
button
once.
The display shows
6.1
. All LEDs
light up.
Table 080-35:
Service Mode Summary, G 1470/G 2470
4.3.5
Optima - G 1472/G 2472
Initial
requirements:
1. Open the door.
2. Switch off the appliance.
Accessing:
1. Press and hold the
Program
button.
2. Switch on the appliance.
3. Release the
Program
button.
4. Immediately press the
Program
button 3 times; on the 3rd time, hold until
the “Rinse & Hold” LED flashes.
Summary of Contents for ADVANTA G 2170
