11817 Rev. A
4. Operator Maintenance
Lubrication
4-5
40hr maintenance due
When this message appears, go into the
40
hour lubrication menu
, then press
When
upper connecting rod
displays, press
. This moves the needle case to its proper
position for oiling (needle 1 and 180° of z axis).
Figure 4-7 shows the lubrication hole inside the
machine. Insert the oiler through the square hole
next to the red dot on the right side of the head.
Press
when done.
You must perform this operation to clear the
message.
80hr maintenance due
When this message appears, go into the
80
hour lubrication menu
, then press
Refer to the steps below to lubricate each area.
Note: If you have a cap frame driver attached,
you must remove it before stepping
through this menu.
1. When
upper/lower needle bar
displays,
press
. No motion is required.
Refer to Figure 4-8 to lubricate the upper
and lower needle bars. Lubricate the needle
bars for all ten needles. Press
when done.
▲
Figure 4-7
Put 1-3 drops of
oil here
▲
▲
Put 2-3
drops of oil
here
Put 2-3
drops of oil
here
Figure 4-8
▲
▲
Red dot
Summary of Contents for EMT 10/4
Page 52: ...2 28 Quick Start Operation Manual for the EMT 10T 10 4 and 10 4T Melco Embroidery Systems ...
Page 108: ...6 10 Error Messages Operation Manual for the EMT 10T 10 4 and 10 4T Melco Embroidery Systems ...
Page 126: ...INDEX Operation Manual for the EMT 10T 10 4 and 10 4T ...
Page 127: ...Quick Ref erence Guide for the EMT 10T 10 4 and 10 4T 11817 Revision A ...