Melco EMT 10/4, Installation, Operation And Maintenance Manual

Page: 39 / 130

The Menus 2-15
11817 Rev. A 2. Operation
Configuration Menu
This menu allows you to configure certain options. Normally these options are only configured
once, but you may set them as often as you wish. If a hard reset is performed, all these values will
return to their default values. If your periphal is not equipped with trimmers, some of these
menus may not appear. The options follow:
Thread trimmer:
Disables or enables the trimmers. Enabled is the default. Press or to
change.
Trimmer tail length:
Allows a short or long tail length after a trim. Short is the default. Press or
to change.
Trim on stitch length:
The stitch length defined here forces a trim when the next stitch is equal to or greater than the
selected length. The allowable range is 0-127. 0 disables the option. 127 is the default. Press
or to change.
Bobbin detect:
Turns ON or OFF the Under Thread Control
(UTC). ON is the default. On the EMT 10T,
press
or to change.
On the EMT 10/4 or 10/4T, refer to the
illustration to the right to turn it on or off
on individual heads. A
0 means the bobbin
detect is turned on for that head, a -
means it is turned off.
Bobbin detect count:
Allows for selection of consecutive bobbin breaks before machine stops. The allowable range is 0-
50. 0 disables the option. 8 is the default. Press
or to change.
Lock stitch:
Forces a lock stitch to be inserted at the beginning of every design and on every restart after a
trim. Enabled is the default. Press
or to change.
Accumulate needle ups:
Accumulates consecutive needle ups and converts them into one motion. Enabled is the default.
Press
or to change.
Return to design origin at EOD (end of design):
Forces an X/Y motion back to the position at the start of the design if the end point is not the
same. Enabled is the default. Press
or to change.
▼
▲
▼
▲
▼
▲
▼
▲
▼
▲
▼
▲
▼
▲
▼
▲
Press or to change a character
Press or to
change the cursor position
▲
▼
▲
▼