Procedures for Testing with the DX Host
megger.com
113
4.
Check the
Status Bar
to ensure the
Active Folder
and
Active Record
fields display the
intended target destinations for your test data.
Figure 125. Armature span test start screen.
5.
Ensure the configuration icon displays the
Standalone
icon.
6.
Touch the
Surge
icon in the mode menu.
7.
Touch the
Coil mode selection
icon then the
Arm Span
icon.
8.
Select a starting point armature bar span to use as a reference. For example, bar 1 and
bar 5 and place the probes on these bars to start the process.
9.
From this point, the process is the same as testing single coils. Refer to the “Surge
testing procedure for single-coil mode” found earlier in this chapter for detailed
instructions.
NOTE: When testing armatures, apply the surge pulse until you see the EAR graph add the new bar
information. Releasing the PTT, footswitch, or fixture button too soon can result in a collapsed waveform
and errant test data being collected.
10.
When you have completed testing all bars of the armature, return the
Voltage Output
Control
knob to
Min
(full counterclockwise rotation).
Summary of Contents for Baker DX
