EXTender
TM
7000 Installation Guide
Page 63
MI Path
Configuration->WAN->T1/PRI_Port(WAN3)->T1/PRI_Port_1->
Channel Setup->DS0_Default
Figure 4-15: DS0_Default Menu
9.
Set the
Enabled
parameter to
Yes
.
10. Set the
Direction
parameter to indicate which direction data will travel. The value
Both
means the chan-
nel will handle both inbound and outbound traffic.
11. Enter a two digit integer into the
Services
parameter. This parameter enables you to select the services
you wish to use to connect to the Central Office (CO). The values most commonly used are
80
(voice
calls) and
82
(64K clear channel).
If you intend to use the port to access local trunks, set the
Services
parameter to
80
.
12. Set the
Connect Type
parameter to
Dialup
.
Verify Successful Synchronization
Once the above settings are configured, then the MCK T1/PRI card should be able to sync up to the T1 line
.
1.
Look at the MCK T1/PRI card in the back of the unit. If the CO and the MCK T1/PRI card are correctly
synchronized, the LED on the T1/PRI card should be solid Green.
Identifying the Local Trunk Port
You must identify one of the MCK T1/PRI ports as the Local Trunk port to support Local Dialing.
1.
Access the
Local Trunk
menu using the following path:
MI Path
Configuration->Services->Local_Trunk
This menu has a single parameter:
T1/PRI Port
.
Figure 4-16: Local Trunk Parameter
2.
Set this parameter to
T1/PRI_Port 1
.
